AUTOOL CT160 Heated 4-Cylinder Fuel Injector Cleaning Machine & Tester

CT160 combines heated ultrasonic cleaning, four-injector testing, adjustable pressure, drain valves, and an English-labeled control panel in one compact unit. Follow the CT160 sequence: clean the injector exterior, run heated ultrasonic cleaning, install injectors on the main unit, add test fluid, and perform leakage, spray-pattern, and flow-rate tests. Keep pressure, pulse width, test time, fluid, injector installation, and selected operating mode identical for every comparison. Review each row in sequence so the observed result leads directly to a retest, cleaning, diagnosis, or replacement decision. Correct fluid selection is critical for CT160. Use cleaning fluid only in the ultrasonic tank and test fluid only in the injector testing circuit, and follow the compatibility rules for standard gasoline, motorcycle, and diesel injectors. Compare CT160 with other AUTOOL fuel injector cleaner and tester machines before choosing cylinder capacity, heating, injector type support, language setting, pump count, and advanced testing capability. Use this overview to identify the models you want to compare in detail. Key features • Heated Cleaning for Four Injectors: Clean compatible standard 12 V gasoline injectors in a 2,000 mL ultrasonic tank heated up to 45°C. • See Differences Side by Side: Compare leaks, spray pattern, spray volume, and relative flow across up to four injectors before deciding what needs further service. • Verify the Cleaning Result: Repeat the same test settings after ultrasonic cleaning to see whether imbalance, restriction, or spray quality improves. • Test Across Operating Conditions: Check injector behavior through idle, medium-speed, high-speed, acceleration, and variable-speed simulations. • Core capacity and control: Slide / drag 1 / 1 • Injector coverage and settings: Slide / drag 1 / 1